Home » Uncategorized

What two actions will the EIGRP DUAL FSM take if a link to a network goes down? (Choose two.)

November 30th, 2009 | admin | 0 Comments »

query neighbors for a new route
search topology table for a feasible successor

digg

delicious

stumbleupon

technorati

Google

live

Sphinn

Mixx

newsvine

reddit

yahoomyweb

This post was written by:

admin - who has written 933 posts on http://learn-ccna.com.

Email This Author | admin's RSS

Comments (0)

There are no comments for this post.

Trackbacks - Pingbacks (0)

There are no trackbacks for this post.

Leave a Reply

Recent Posts
- Several Ethernet hosts on a LAN need the gateway services of a Cisco 2500 series router. Which of the following would be needed to physically connect a router to all of the hosts on the LAN? (Choose two.)
  ome here : http://learn-ccna.com/?s=Several+Ethernet+hosts+on+a+LAN+need+the+gateway+services+of+a+Cisco+2500+series+router.+Which+of+the+following+would+be+needed+to+physically+connect+a+router+to+all+of+the+hosts+on+the+LAN%3F+%28Choose+two.%29
- Which value determines if a switch becomes the central point of reference in the spanning tree topology?
  highest revision number highest numeric MAC address lowest numeric IP address lowest bridge...
- Refer to the exhibit. Which two settings show the default value of VTP configuration on a Cisco 2960 switch? (Choose two.)
  existing VLANs operating mode domain name pruning mode revision number
- Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.65 and a destination address of 192.168.1.161. What will the router do with this packet?
  The router will forward the packet out interface FastEthernet 0/1.1. The...
- Refer to the exhibit. Hosts A and B, connected to hub HB1, attempt to transmit a frame at the same time but a collision occurs. Which hosts will receive the collision jamming signal?
  only hosts A, B, C, and D only hosts A, B,...
Recent Comments
Popular Tags
Refer to the exhibit. A host connected to Fa0/0 is unable to acquire an IP address from the DHCP server. The output of the debug ip dhcp server command shows “DHCPD: there is no address pool for 10. Refer to the exhibit. Every time the administrator reboots this router the boot process ends in setup mode. What is a possible problem? Which option correctly defines the capacity through the local loop guaranteed to a customer by the service provider?

counter on godaddy