1. Refer to the exhibit. The network administrator wants to create a subnet for the point-to-point connection between the two routers. Which subnetwork mask would provide enough addresses for the point-to-point link with the least number of wasted addresses?
ans:
255.255.255.252

2. An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following subnet addresses can be configured in this network to provide a maximum of 14 useable addresses for this link while wasting the fewest addresses?
ans:
192.1.1.224/28

3. Refer to the exhibit. A network engineer is summarizing the two groups of routes on router R1 shown in the exhibit. Which summarization will work for all the subnets?
ans:
192.168.0.0/21

4. What is a supernet?
ans:
a summarization of serveral IP classful networks into one IP address range

5. In the network shown in the graphic, three bits were borrowed from the host portion of a Class C address. How many valid host addresses will be unused on the three point-to-point links combined if VLSM is not used?
ans:
84

6. What does VLSM allow a network administrator to do?
ans:
utilize multiple subnet masks in the same IP address space

7. Refer to the exhibit. The network administrator wants to minimize the number of entries in Router1’s routing table. What should the administrator implement on the network?
ans:
CIDR

8. Refer to the exhibit. A network technician enters the static route in R1 needed to reach network 10.1.1.0/24. A ping from the S0/0/0 interface on R1 to host B fails. The technician begins testing the network and has the following results:
1. pings from R1 to the S0/0/0 interface on R2….successful
2. pings from R1 to the Fa0/0 interface on R2….successful
3. pings from host B to hosts on the 10.1.1.0/24 network….successful
4. pings from host B to the Fa0/0 interface on R2….successful
5. pings from R2 to host B….successful.
What is the likely cause of the failure of the ping from R1 to host B?
ans:
The default gateway on host B is not correctly set.

9. Which three interior routing protocols support VLSM? (Choose three.)
ans:
OSPF
RIP v2
EIGRP

10. Refer to the exhibit. A network administrator needs to create two subnetworks from 10.0.0.0/8 for a router running RIPv2. The Admin subnet requires 120 hosts and the Sales subnet requires 58 hosts. The network administrator assigned 10.0.1.128/25 to the Admin subnet. The Sales subnet is given 10.0.1.192/26. What will be the result of this addressing scheme?
ans:
The subnets overlap and will be rejected by the router.

11. Which of the following are contained in the routing updates of classless routing protocols? (Choose two.)
ans:
32-bit address
subnet mask

12. A Class C address has been assigned for use in the network shown in the graphic. Using VLSM, which bit mask should be used to provide for the number of host addresses required on Router A, while wasting the fewest addresses?
ans:
/27

13. Refer to the exhibit. The number of required host addresses for each subnet in a network is listed in the exhibit. This number includes the host address requirements for all router ports and hosts on that subnet. After all device and router port address assignments are determined, what will be the total number of unused host addresses available?
ans:
29

14. What two advantages does CIDR provide to a network? (Choose two.)
ans:
reduced routing table size
reduced routing update traffic

15. A network administrator is tasked with dividing up a class C network among the QA, Sales, and Administration departments. The QA department is made up of 10 people, the Sales is made up of 28 people, and the Administration has 6. Which two subnets masks adequately address the QA and Sales departments? (Choose two.)
ans:
255.255.255.224 for Sales
255.255.255.240 for QA

16. Refer to the exhibit. In the network that is shown, the router interfaces are assigned the first address in each subnet. Which IP address would be usable for a host on one of the LANs in this network?
ans:
192.168.2.130/25

17. Refer to the exhibit. Which address is a broadcast address for one of the subnets that are shown in the exhibit?
ans:
192.168.4.15/29

18. Refer to the exhibit. What subnet mask will be applied by router B when it receives a RIPv1 update for the network 172.16.1.0?
ans:
24

19. Which of the following problems does VLSM help to alleviate?
ans:
the shortage of IP addresses

20. A router has a summary route to network 192.168.32.0/20 installed in its routing table. What range of networks are summarized by this route?
ans:
192.168.32.0 – 192.168.47.0/24

source : answersforccna

1. Which two statements about DSL are true? (Choose two.)
• users are on a shared medium
• uses RF signal transmission
• local loop can be up to 3.5 miles (5.5km)
• physical and data link layers are defined by DOCSIS
• user connections are aggregated at a DSLAM located at the CO

2. Which two Layer 1 requirements are outlined in the Data-over-Cable Service Interface Specification (DOCSIS)? (Choose two.)
• channel widths
• access method
• maximum data rate
• modulation techniques
• compression techniques

3. Which two statements are valid solutions for a cable ISP to reduce congestion for users? (Choose two.)
• use higher RF frequencies
• allocate an additional channel
• subdivide the network to reduce users on each segment
• reduce the length of the local loop to 5.5 kilometers or less
• use filters and splitters at the customer site to separate voice from data traffic

4. A technician has been asked to configure a broadband connection for a teleworker. The technician has been instructed that all uploads and downloads for the connection must use existing phone lines. Which broadband technology should be used?
• cable
• DSL
• ISDN
• POTS

5. After conducting research to learn about common remote connection options for teleworkers, a network administrator hasdecided to implement remote access over broadband to establish VPN connections over the public Internet. What is the resultof this solution?
• A reliable connection is established at greater speeds than what is offered from dialup over POTS. Security is increased, but username and password information are sent in plain text.
• The connection has increased security and reliable connectivity. Users need a remote VPN router or VPN clientsoftware.
• Security and reliability are increased at a substantial loss in throughput, which is considered acceptable when supporting asingle user environment.
• Reliability and security are increased without the need for additional equipment, when compared to dialup connections usingPOTS.

6. What are the three main functions of a secure VPN? (Choose three.)
• accounting
• authentication
• authorization
• data availability
• data confidentiality
• data integrity

7. Which two methods could an administrator use to authenticate users on a remote access VPN? (Choose two.)
• digital certificates
• ESP
• hashing algorithms
• smart cards
• WPA

8. Data confidentiality through a VPN is achieved through which two methods? (Choose two.)
• digital certificates
• encryption
• encapsulation
• hashing
• passwords

9. Data confidentiality through a VPN can be enhanced through the use of which three encryption protocols? (Choose three.)
• AES
• DES
• AH
• hash
• MPLS
• RSA

10. Which is an example of symmetric-key encryption?
• Diffie-Hellman
• digital certificate
• pre-shared key
• RSA signature

11. Which statement describes cable?
• Delivering services over a cable network requires downstream frequencies in the 50 to 860 MHz range, and upstreamfrequencies in the 5 to 42 MHz range.
• The cable subscriber must purchase a cable modem termination system (CMTS)
• Each cable subscriber has dedicated upstream and downstream bandwidth.
• Cable subscribers may expect up to 27 Mbps of bandwidth on the upload path.

12. A company is using WiMAX to provide access for teleworkers. What home equipment must the company provide at theteleworker’s site?
• a WiMAX tower
• a one-way multicast satellite
• a WiMAX receiver
• an access point connected to the company WLAN

13. Which two features can be associated with the Worldwide Interoperability for Microwave Access (WiMAX)telecommunication technology? (Choose two.)
• supports municipal wireless networks utilizing mesh technologies
• covers areas as large as 7,500 square kilometers
• supports point-to-point links, but not full mobile cellular-type access
• connects directly to the Internet through high-bandwidth connections
• operates at lower speeds than Wi-Fi, but supports many more users

14. While monitoring traffic on a cable network, a technician notes that data is being transmitted at 38 MHz. Which statementdescribes the situation observed by the technician?
• Data is being transmitted from the subscriber to the headend.
• Data is flowing downstream.
• Cable television transmissions are interfering with voice and data transmissions.
• The system is experiencing congestion in the lower frequency ranges.

15. Refer to the exhibit. All users have a legitimate purpose and the necessary persissions to access the Corporate network.
• Based on the topology shown, which locations are able to establish VPN connectivity with the Corporate network?
• Locations C, D, and E can support VPN connectivity. Locations A and B require an additional PIX Firewall appliance installedon the edge of the network.
• Locations C and E can support VPN connectivity. Locations A, B, and D require an additional PIX Firewall appliance installed on the edge of the network.
• Locations A, B, D, and E can support VPN connectivity. Location C requires an additional router on the edge of the network.
• All locations can support VPN connectivity.

16. What two protocols provide data authentication and integrity for IPsec? (Choose two.)
• AH
• L2TP
• ESP
• GRE
• PPTP

17. Which two protocols can be used to encapsulate traffic that is traversing a VPN tunnel? (Choose two.)
• ATM
• CHAP
• IPsec
• IPX
• MPLS
• PPTP

18. Refer to the exhibit. A teleworker is connected over the Internet to the HQ Office. What type of secure connection can be established between the teleworker and the HQ Office?
• a GRE tunnel
• a site-to-site VPN
• a remote-access VPN
• the user must be at the office location to establish a secure connection

19. Refer to the exhibit. A VPN tunnel has been established between the HQ Office and the Branch Office over the public Internet. Which three mechanisms are required by the devices on each end of the VPN tunnel to protect the data from being intercepted and modified? (Choose three.)
• The devices must use a dedicated Layer 2 connection.
• The devices must have the VPN client software installed.
• The two parties must inspect the traffic against the same ACLs.
• The two parties must establish a secret key used by encryption and hash algorithms.
• The two parties must agree on the encryption algorithm to be used over the VPN tunnel.
• The devices must be authenticated before the communication path is considered secure.

View From Source

channel widths
modulation techniques

2. Which is an example of symmetric-key encryption?

pre-shared key

3. Which two statements are valid solutions for a cable ISP to reduce congestion for users? (Choose two.)

allocate an additional channel
subdivide the network to reduce users on each segment

4. While monitoring traffic on a cable network, a technician notes that data is being transmitted at 38 MHz. Which statement describes the situation observed by the technician?

Data is being transmitted from the subscriber to the headend.

5. After conducting research to learn about common remote connection options for teleworkers, a network administrator has decided to implement remote access over broadband to establish VPN connections over the public Internet. What is the result of this solution?

The connection has increased security and reliable connectivity. Users need a remote VPN router or VPN client software.

6. Data confidentiality through a VPN is achieved through which two methods? (Choose two.)

encryption
encapsulation

7. Data confidentiality through a VPN can be enhanced through the use of which three encryption protocols? (Choose three.)
AES
DES
RSA

8. What two protocols provide data authentication and integrity for IPsec? (Choose two.)
AH
ESP

9. A technician has been asked to configure a broadband connection for a teleworker. The technician has been instructed that all uploads and downloads for the connection must use existing phone lines. Which broadband technology should be used?

DSL

10. What are the three main functions of a secure VPN? (Choose three.)

authentication
data confidentiality
data integrity

11. A company is using WiMAX to provide access for teleworkers. What home equipment must the company provide at the teleworker’s site?

a WiMAX receiver

12. Which two methods could an administrator use to authenticate users on a remote access VPN? (Choose two.)
digital certificates
smart cards

13. Which two statements about DSL are true? (Choose two.)

local loop can be up to 3.5 miles (5.5km)
user connections are aggregated at a DSLAM located at the CO

14. Which two features can be associated with the Worldwide Interoperability for Microwave Access (WiMAX) telecommunication technology? (Choose two.)

covers areas as large as 7,500 square kilometers
connects directly to the Internet through high-bandwidth connections

15. Refer to the exhibit. All users have a legitimate purpose and the necessary persissions to access the Corporate network. Based on the topology shown, which locations are able to establish VPN connectivity with the Corporate network?

All locations can support VPN connectivity.

16. Which statement describes cable?

Delivering services over a cable network requires downstream frequencies in the 50 to 860 MHz range, and upstream frequencies in the 5 to 42 MHz range.

17. Which two protocols can be used to encapsulate traffic that is traversing a VPN tunnel? (Choose two.)

IPsec
PPTP

18. Refer to the exhibit. A teleworker is connected over the Internet to the HQ Office. What type of secure connection can be established between the teleworker and the HQ Office?

a remote-access VPN

19. Refer to the exhibit. A VPN tunnel has been established between the HQ Office and the Branch Office over the public Internet. Which three mechanisms are required by the devices on each end of the VPN tunnel to protect the data from being intercepted and modified? (Choose three.)

The two parties must establish a secret key used by encryption and hash algorithms.
The two parties must agree on the encryption algorithm to be used over the VPN tunnel.
The devices must be authenticated before the communication path is considered secure.